Search:

Type: Posts; User: sakorick; Excluded Forums: Milsurp Knowledge Libraries (READ ONLY)

Search: Search took 0.05 seconds.

  1. Replies
    21
    Views
    2,994

    Reading it now....real good stuff.

    Reading it now....real good stuff.
  2. Replies
    21
    Views
    2,994

    I'll check my carbine club newsletters but I...

    I'll check my carbine club newsletters but I think you are correct.
  3. Replies
    21
    Views
    2,994

    My rifle was manufactured on March 23, 1943.

    My rifle was manufactured on March 23, 1943.
  4. Replies
    21
    Views
    2,994

    Don't worry, I won't even think about removing it...

    Don't worry, I won't even think about removing it and thanks for the education. When did they change the pin to the headed style?
  5. Replies
    21
    Views
    2,994

    Wrong, I appreciate constructive suggestions and...

    Wrong, I appreciate constructive suggestions and always have, Moo.
  6. Replies
    21
    Views
    2,994

    Got it....yes it has been broken but it can't be...

    Got it....yes it has been broken but it can't be removed. This is the first early Winchester that I have actually touched and didn't know what the pin was for. I did not see the hammer pin installed...
  7. Replies
    21
    Views
    2,994

    It doesn't look cut off to me....there is still a...

    It doesn't look cut off to me....there is still a tip there. The fact is that it is an original part. The whole rifle has original parts. I am done with this forum as all you guys want to do is find...
  8. Replies
    21
    Views
    2,994

    Additional pictures added...hope you like them....

    Additional pictures added...hope you like them. The friction pin I had never seen before but after monkeying with it I can see why it was eliminated! The best way I found was to start the pin in the...
  9. Replies
    21
    Views
    2,994

    That's is not a punch mark, it's a ding. I don't...

    That's is not a punch mark, it's a ding. I don't know what to make of the other mark under the rear sight, under magnification it looks like small dings in a line.
  10. Replies
    21
    Views
    2,994

    I'm real busy tomorrow but will disassemble for...

    I'm real busy tomorrow but will disassemble for internal soon. Thanks for the comments.
  11. Replies
    21
    Views
    2,994

    Picked up a Winchester

    PI found this one for me. This is one from the first block SN1049220 and I waited a long time for it. The OC cartouche is on it's side and the SN is a mess but all the parts seem correct. ME is 1.5....
Results 1 to 11 of 11
Warpath Vintage