-
FREE MEMBER
NO Posting or PM's Allowed
-
10-07-2012 09:39 PM
# ADS
Friends and Sponsors
-
Legacy Member
Slightly enlarge the hole in the stock to allow the retaining bolt to move a little more freely and find the threaded portion in a better position.
-
-
-
Did you try tapping the front of the upper band with a block of wood and a hammer? Sometimes due to swelling in the wood, the upper band doesn't line up properly.
People sleep peaceably in their beds at night only because rough men stand ready to do violence on their behalf.
--George Orwell
-
-
Advisory Panel
i suspect this is a 1903A3, since they are a bear to get done.
loosen the stacking band, and then line the hole up and try it.
over sizing the hole works, but should be done as a last resort.
-
-
Legacy Member
Try putting on a bayonet and use it for leverage . As was said , you've got to align it juuussssst right.
Chris
-
-
FREE MEMBER
NO Posting or PM's Allowed
Success! thanx for hints, cleaned up stock hole slowly and..poof! it went thru. thanx to all, great forum for info!............steve