-
FREE MEMBER
NO Posting or PM's Allowed
Hello! Need help identifying an old Enfield
-
12-18-2014 07:45 PM
# ADS
Friends and Sponsors
-
Legacy Member
Looks to be a British
made, 1944 vintage No 4 Mk 1 rifle; although the safety lever is Canadian
.
I'm guessing it might have been made at ROF Fazakerley.
Last edited by Maxwell Smart; 12-18-2014 at 08:29 PM.
-
-
-
FREE MEMBER
NO Posting or PM's Allowed
You have a pile of scrap I'd throw in a bin....
-
Legacy Member
Says it in the first picture, No4Mk1. Hammer is cocked.
-
-
FREE MEMBER
NO Posting or PM's Allowed

Originally Posted by
ssj
You have a pile of scrap I'd throw in a bin....
Fella that gave it to me says it fires -- he was brave enough to shoot it once.
The bolt works perfectly. I'm in the process of lubing it up and getting some of the rust off now.
-
Legacy Member
Florida, eh?
"Shark-repellant" on a fishing-boat for a few years, perhaps?
'Gator "adjuster"?
Or really slack owner?
I've seen a few (mostly SMLEs) like that in North Queensland; sad, really.
-
-
Advisory Panel
I'd say it would be a miracle if the pipe is ok on that one. If it isn't, I wouldn't bother doing anything. Scrap it out.
-
-
FREE MEMBER
NO Posting or PM's Allowed
It`s a 1944 No.4 Mk1* Long Branch, go forth and clean her up !......................
-
Legacy Member

Originally Posted by
303tom
It`s a 1944 No.4 Mk1* Long Branch, go forth and clean her up !......................
Suggest have another good look at picture #2 ...
There is a bolt-head catch, and no cut-out in the boltway - therefore it is not a MK 1*.
Since North American production by 1944 was all Mk1*; the clues indicate a British
rifle
Last edited by Maxwell Smart; 12-18-2014 at 10:32 PM.
-
-
Legacy Member

Originally Posted by
Maxwell Smart
Suggest have another good look at picture #2
A closer look at butt socket markings in pic #1 shows part of an ''M'' sticking out from under the rust next to the DOM and a ser. no. that starts with a 1. It's a Maltby. ............Or whats left of one at least.
Last edited by vintage hunter; 12-18-2014 at 11:14 PM.
-