280 Ross barrel

[eliwhitley@yahoo.com]

I need some thoughts on what to do with this barrel. It is a Ross commercial 280 barrel. A 280 Ross shell fits right into the chamber. The barrel is marked with tape 338. The bore is definitely larger than 280. I do have a military Ross 1910 receiver that it screws right into.

So. Any thoughts on what I can do with this setup?

Don

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[steveu]

I think you need to do a chamber cast to see what you have.

[Surpmil]

So you may have a .280 that was re-bored when the barrel wore out.

Are the threads square in form or standard?

[browningautorifle]

Perhaps slug the bore to be sure of diameter and set your mind at rest.

[eliwhitley@yahoo.com]

IT'S DEFFINATELY A SQUARE TOP. BUT I CAN'T TELL WHICH ONE.

Thanks, Don

[Surpmil]

Once you've done the chamber cast you'll know if you have a wildcat based on the .280 case or something else.