1910 280

[AGB-1]

ross m10 m-10 280 ross rough shape great for parts or refinish - Rifle Bolts at GunBroker.com : 907017731
someone ought this one. I believe it would clean up and make a nice rifle.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[tiriaq]

Certainly potential is there. Cross the fingers and hope the bore cleans up. Receiver ring is already drilled and tapped, so setting up a rear bridge for a base wouldn't be a sin.

[Surpmil]

In these days of water jets it should be easy enough to cut out a wrench for the 1910 action, and get new barrels made.

[tiriaq]

Never even considered water jet cutting the opening for a receiver wrench. Great idea! That makes a lot of sense. Might even be a market for them, for various firearms.

[Warren]

Be very careful on making any plans with a 280 Ross that involve money.
I have owned, shot and handled good number over the past 60 years and never saw one with a pristine barrel.
Most are shot out.... or worn to the point that it is not worth investing money on it unless you want to have a nice shiny wall hanger.