S'G' 3237965, rear sight, stake marks?

[Garandrew]

Coulld S'G' 3237965, reciever have flip sight, BIP, and RP/S, where 2 tiny punch marks were used, unlike slit type stake marks, these are tiny punches?
I remember something in a thread about that?
Please help? Andy

http://webmail.aol.com/43661/aol/en-...=1969&z=118132

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[painter777]

Since Saginaw Steering Gear took over the cancelled contract from IP, it would seem very possible that a IP flip sight could be found on a S'G' carbine.
Original carbines have been documented with both the chisel and very small punch mark type staking.

FWIW

Charlie-painter777

[STU1]

yep, it's possible

[Garandrew]

Here it is..on auction
http://www.gunbroker.com/Auction/Vie...Item=132975529
Note the punch marks dont look like they are for this sight, or did I lose out..it was mine in a trade, if I wanted it?? Andy

[STU1]

if it was needed to fill a gap in a collection of one OF every as maunufactured M1 Carbine collection, i'd pick it up or if it upgrades and existing rifle of the same make JMHO