WRA Housing.

[Mikey51]

Re - Parked or not ?. I'm trying to learn more about "colours". Found this on the re-built S.G. , the one in the RMC stock I mentioned a few weeks back. Thanks. Mike.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[wtmr]

post a pic showing the milling on actual trigger guard on bottom

[Wulf]

I vote original.

[Dr342]

I would leave it as is.

[Bruce McAskill]

Been through a rebuild and has been parkerized. The oiler hole is the key.

[Bill Hollinger]

+ one for repark. In addition to the oil hole note it is re-parked over a great deal of nicks, scratches and dings.

[DaveHH]

................

Attachment 20521

[Mikey51]

These pics O.K wtmr ? Also found a BE-B on Quality #1554234 receiver if anyone looking for one. Mike.Attachment 15868Attachment 15869Attachment 15870Attachment 15871Attachment 15872

[Bubba-7]

Most trigger housings had a type 1 or 2 dog leg hammer at one time so the strike mark is in a different location than marks for a thpe 3 hammer. A view of the top will show either two sets of strike marks, one refinished over or only one strike make not finished over.

[Mikey51]

Thanks Bubba, ( I am 90% sure that I know who you are ). The subject of strike marks from previous hammers is something I am anxious to learn more about. Here it is from the top, the same WRA housing I started the thread with. Your opinion would be very much appreciated. Mike.