and his generosity in supplying me with a MH short lever, I can
now shoot my MH IV from the bench without having to stand up
in order to eject.
Obviously not wanting to alter my orig buttstock, in case I ever decide to sell the rifle,
I was concerned
that without the brass stock cup it might not go into battery.
It did - I fired a case with just a primer - firing pin hit dead center.
As a matter of interest, I was having a helluva time getting the
breechblock to pop in unti I added a few gobs of grease to the slot.
It popped right in.
Just goes to show - "A little dab'll do ya"
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.