CMP WRA drill rifle and WRA rack grade.

[Prince Humperdink]

Hi Fellas,
I recently gambled on a WRA rack grade,and a Drill rifle from CMP and I'm quite pleased.The rack grade was all SA except for the Win 13 receiver,and the barrel was a 9-44 SA barrel.The trigger group was all HRA,as was the gas cylinder and front sight,lock and screw.The stock is an EMcF that is partially readable.The heel stamp is very deep and crisp

The Drill rifle turned out to be a 1.2 mil range WRA,and was lovely w/dark annealing and deep,crisp heal stamp.I think this rifle was fresh from rebuild when it was welded,as it had a new 9-46 barrel,new birch stock,and new looking internals.I was able to take off the barrel as it was welded mostly on it and not the receiver,and ended up with a lovely receiver,op rod,hardly used -14 SA trigger group,stock set,rear sight,internals,front sight,and gas cylinder lock and make a good rifle.I did add it to a long channel GHD stock though.I think it was worth the price,but I've heard most are junk.
well,here are a few pics...enjoy.
as received Drill rifle:





---------- Post added at 12:17 AM ---------- Previous post was at 12:15 AM ----------



and now the rack "befores":




---------- Post added at 12:23 AM ---------- Previous post was at 12:17 AM ----------

here are the "afters".Win-13 in short channel GHD,and former drill in long channel GHD,now,if only the range would open so I could shoot them!
X-drill:






and now the"racker":

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.