loose cocking piece 303 no.4

[Hornant]

Can anyone give me a good way take the play out of the cocking peice to firing pin fit.

Thanks

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[JBS]

The correct way is to peen slightly the first three treads on the end of the rod. A tool for doing this was made from a slab side cocking piece. The easy way to do it is a drop of blue locktite. Allow the locktite to cure for several hours before you reinstall the lock screw. No need to locktite that little screw.