loading 7.62x 39 with taper crimp?

[duggaboy]

just began loading the ammo for an AK47, using a Redding Taper Crimp after seating the bullet into the case. Has anyone used this type Redding crimp versus the other type? Any pro's and con's? thanks

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[JBS]

I have used a taper crimp, roll crimp, and "factory" crimp on 7.62X39 without any trouble. Don't over do it with the taper crimp as you "can" squize the bearing surface of the bullet down to much.

[duggaboy]

ok , so what is the difference between the crimping dies. and what type of crimp is best/easier or whatever to use?

[JBS]

Bullet and cartridge dependant. Bullets with a canuler are best served with a roll or “factory” crimp. Cartridges that head space on the case mouth are best served with a taper crimp.

[TDH]

The crimp employed in my seating die seems to work just fine. I have found that adding any other or more crimp actually decreases the accuracy in my rifle