Ammo for an Ishapore

[ShaveTail]

I ordered what looks like a very sound Enfield 2a the other day. What is a safe ammunition to use? I keep reading that commercial .308s are dangerous, or at least long-run destructive to headspace. So what do you guys shoot? I don't hand load yet, so I'm looking at surplus military NATO ammo. Does this stuff sound safe? Paki milsurp:

http://www.ammunitiontogo.com/catalo...l-308-762-nato

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[jona]

308 either military OR civilian will be just fine.

[Edward Horton]

Below are two good links to read, and also remember there is a difference between rated chamber pressure and actual chamber pressure. Factory loaded ammunition for the British .303 is kept below 43,000 CUP (actual) but the rated pressure is 46,000 CUP or 49,000 PSI.

The actual chamber pressure for the .308 is actually LOWER than the 7.62 NATO.

Is it safe to shoot 308 Winchester in a rifle chambered for 7.62 NATO?
What about 7.62 in a 308?
By Jim Bullock

http://www.smellysmleshooters.net/ammopressure.htm

The Truth About 7.62x51mm NATO and 308 Winchester

http://www.google.com/url?sa=t&sourc...EjYDYEkYiUH5Qg

[buddyjaet]

Long term solution is to reload your own ammo..
I have been reloading for many years, milsurp brass is thicker than commercial brass. The military chamber is for lack of a better word, looser than a commercil chamber. The other posters put up several great articles on the subject, I have read them all and the points are all good. The SAMMI specification commerical ammo will cause higher pressures if fired from a MILSURP rifle with a chamber that is not close to SAMMI spces. If you have fired the weapon, check your brass and primer, how do they look. I was very lucky with 2A and 2A1, both chambers were in excellent condition and no evidence of problems with pressure.

Wincheser makes a white box 7.62 NATO cartridge that I have fired in my 2A with good results. Of course its reloadable brass. If you are not a reloaded it is certainly a good idea; certianly if you are going to continue to shoot MILSURP weapons. I have fired .308 Wincheseter ammo and my 2A showed no indication of overpressure on the fired brass.

As always if you doubt your weapon or do not know its history then PLEASE have it checked by a competent gunsmith.

[Edward Horton]

A longer and fatter military chamber (looser than a commercial chamber) will not raise or increase chamber pressures if commercial ammunition is fired in a military rifle chamber. (how do you increase chamber pressure by increasing chamber volume or area?)

You have less than 2,000 PSI (transducer method) difference between the chamber pressure "ratings" of the 7.62 NATO and the .308 Winchester, which is insignificant.

Below is ballistic pressure testing done by the reloading company Lyman on the the 180 grain 30-06 made by Winchester. Looking at the bottom of this photo you will see the "Extreme Variation" is over 10,000 PSI and the "Standard Variation" is over 3,000 PSI.
(test rounds No.3 and No.4 had over 10,000 PSI difference on firing)

Again the pressure difference of less than 2,000 PSI between the .308 and 7.62 NATO is insignificant. The biggest differences between the .308 and 7.62 is case construction with military cases being constructed heavier to withstand the rigors of combat.




We did NO damage firing commercial ammunition in our American M-1917 and 03 Springfield's and we had the same rated pressure difference between commercial and military 30-06 ammunition as the .308 and 7.62 NATO.

The only thing that happens is commercial cartridge cases do not like being fired in military chambers and tend to stretch in the web area.

Below is a commercially loaded .303 Winchester cartridge case fired in a British Enfield with the head space set at .067, this case stretched .009 in the web area and military HXP ammunition would show NO signs of stretching fired in the same Enfield.



The .308 cases below were reloaded and fired till they separated, and not all cartridge cases are made to the same quality standard.





The above commercial cases would NOT have lasted as long before case separation if fired in a military chamber due to the longer head space and larger diameter chambers of military rifles.

We Americans have been firing our commercial cases(and factory ammunition) in our Enfields for years and what should be noted is the people who complain about head space and case life the most are shooting commercial American SAAMI cases and the people who never complain about head space and case life are using military grade Greek HXP cases for reloading.

[Pattern14]

Hey Ed,
Have you dug out from the last week yet!

[Edward Horton]

Hey Ed,
Have you dug out from the last week yet!

At last we have something to blame on the Australians that they can't deny, our 34 inches of snow was caused by the "El Niño effect". Hot air and warm currents from the east coast of Australia moving eastward and hitting the west coast of North America and mixing with cold Canadian air caused our snow storm on the east coast of the U.S. (every state but Hawaii had measurable snowfall this week)

Below, 18 inches of snow on my truck and my snowblower, please notice the faint dusting of Vegimite on the snow turning it a blackish-brown color.
The odd part is how many friends you have after a snowstorm when you have a snowblower and none of them had any Enfield manuals to trade for the snowblower clearing work.

[jonnyc]

You guys didn't get much, did you? I'm in Phoenixville. We're over 70 inches for the winter...so far. The town where I teach got 26" in this last blast.

[Bindi2]

snow there 46 + deg c here o well.

[jonnyc]

Ah...but no flies here, mate, not to mention box jellies, sharks, dingoes, or endless poisonous insects!