Chinese factory codes

[sandstorm]

there are close to 150 chinese factory codes, below are a small portion of codes i have collected pic on.

please check your Chinese SKS and see if your factory code is on this list , if not, would you kindly post a close up pic of the factory code, the serial numbers (you may block off the last couple of digits) and the area where the barrel meet the receiver (barrel lug) so i may update the table ... thanks

A. Triangle factory codes:


B. Square factory codes:
1.[0134],[0138],[0140],[0141],[0144],[0147].
2.[0221],[0223],[0224],[0306],[6615].

C. Oblong factory codes:
1.(874),(974),(9186),(9696).

D. Diamond codes:
<0216>

E. Plain codes:
M8, M21 No, M21 0296, 416M21, DB, DP.

note: 1.triangle code 0406 or /0406\ is pending
2. code /156\ not exacty as shown.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[jmoore]

Thanks for making a dedicated thread for this subject- It'll be easier to find down the road.

[howiebearse]

I do not belive that you did all that research on these factory codes they have been aquired and put together by me and me alone any copies there off should be posted with the fact they came from me Howie bearse Gunboards.com

[sandstorm]

I do not belive that you did all that research on these factory codes they have been aquired and put together by me and me alone any copies there off should be posted with the fact they came from me Howie bearse Gunboards.com

these codes were gathered from varies sources and most of them are likely from you , sorry for not stating that earlier .