M1903 rear sight tool

[Allen Humphrey]

Attachment 29538Attachment 29537Attachment 29536With full disclosure that I have no business posting in the Gunsmithing section......

Here is a little tool I made for removing and installing that tiny pin in the elevation slide. The screw is an 8-32. I drilled the end with a #57 bit to about .25" deep. I then lopped off 7/16" of the shank of the said #57 and seated it in the hole I had just drilled. That leaves just enough exposed punch to get the pin all the way out without being too flexible. Really better than whacking at it with a hammer and punch.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Rick H.]

Thanks Allen, that certainly does seem to be a much easier way to get that pin out.

Rick H.

[pcaru1]

Awesome. Wish I had this the other day for a pin that just wouldn't come out. Bent two pins whackin it. Still soaking in Blaster.