After much searching I finally found a Combination Tool that I could afford.

It is maker stamped "GHC" and I'm hoping someone has additional information on this manufacturer.

I would also like to verify the function of the tips, please correct me if I'm wrong.
1) the tip with two pins is for the rear sight slider screw/plunger.
2) the tip with the single pin and the small slot is used to remove and replace the extractor spring
3) the large tip with two flat blades with a gap is used to service the 1907 bayonet bolt.
4) the other flat bladed tips are used for various screws around the weapon.
5) the two slots labeled ".04" and "042" are go/no-go firing pin protrusion gages.
6) the small rounded slot to the right of the ".04-.042" slots is a firing pin tip profile gage.

Thanks in advance for any corrections/comments.

D.

Attachment 30542
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.