I have a USGI stock that I use on my IDF sniper when I want to use iron sights. I never liked the look of the open hole in the stock where the selector should be and I wanted to put the selector back on. After checking out the options on the internet I decided to go with the sparrow hawk setup and sent in the money. The fellow from sparrow hawk was very rude and hard to deal with so I got my money back(which in itself was a chore). I bought a selector kit on GB and tried to install it myself which I finally did and I'm fairly pleased with the result. The little pin you see sticking out of the selector switch is a piece of wire that I had holding the switch on temporarily until I put the roll pin in. The switch does rotate 360 degrees like it should.
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.