I'm going to do someone a favor... Type I band screw

[imarangemaster]

I believe my Standard Products Has a longer Type I band screw in it's Type III barrel band. If someone needs a type I screw, send me a Type III screw and I will send the type one screw back to you. I'll do a pic after awhile.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[USGI]

I'd like to take you up on that offer. Let me know if I'm not already too late, and I'll get some close-up pictures of the screw that I have and email them to you. - Bob

[imarangemaster]

It's yours. As long as it is GI screw, it will be fine. Give me an email address and I will send you a picture of the screw I have to see if it is what you want.

Bernie

[USGI]

I'll send you a PM in a few minutes. Thanks! - Bob

[imarangemaster]

[imarangemaster]

The screw shank alone is almost 5/8", about 1/8" longer than a screw on a type II (cut down Type III) I have in my parts stuff. Just figured it is a shame to waste it on a Type III band when someone (like USGI) has a Type I band languishing without a proper screw!

[USGI]

That one looks a bit short for a Type 1, and when I found the one I planned on trading - I'm not positive it's USGI. I PM'd IMR that I decided not to take it. I sure appreciate the offer, though! I think the "exchange" idea is pretty cool. Thanks again! - Bob

[imarangemaster]

It is a tad shorter than mu Type I screw, but longer than my Type III. ?????

[Clash77]

My Type III has a long screw like that too

[imarangemaster]

Sorry about the false start guys. I will stick with the one I have. It is probably original, as the threads on it are upset at the end. Silly me assuming it was a type I screw. It is just under 1/8" shorter than the Type I on my Inland, but still longer than the screw on my Type II/III band.