Mosin stock break down.

[tower06]

Ok, so I am looking to take apart the stock hardware on the Polish sniper I just picked up from a member on another board. The plan is to put it through an electrolysis bath to remove all the small rut spots before it gets too bad. I can do the basic parts removal, but how do I get the brace that sits under the action out. Is that screwed, or pinned in.

Any advice would be appreciated.

Mariusz

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[WarPig1976]

use a pair of snap ring pliers its really just a nut & bolt..

[tower06]

use a pair of snap ring pliers its really just a nut & bolt..

Thanks