Bren engraving Font

[c310pilot]

Does any one happen to know what font was used when engraving the L4's. I am finally getting ready to do the final touches and want to get this right.

thanks

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Brian Dick]

3/16"

[Brit plumber]

You probably have photos of the markings but I thought I'd add a multitude of them. Notice how the 37 is always a little higher than the MG and GA
Attachment 47150
Attachment 47151
Attachment 47152
Attachment 47153
Attachment 47154