Question regaeding GCA article

[Joe W]

Make that "regarding question"
Someone on Culvers Forum asked this question :

"Last edition had an article about what is possibly an "experimental" Garand.
The article states that the custom made gas cylinder has "no gas cylinder lock".
Yet it uses a lock screw.
Does anyone have any idea how that gas cylinder is secured to the barrel?
Just curious.
Chris."

I went back and reread the article thinking I could answer his question but

Hope Bob Seijas or someone else can answer this question. Thanks.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Bob Seijas]

I never thought of that when I examined the gun Tony is aware of the question, promises to look and answer it when he can dig it out.

[Crispy]

I'm new to this forum and have been lurking to see what you folks are made out of.
I asked the question "over there".
Curiosity gets the better of me and eventually I would have asked here.
Chris.

[Joe W]

I'm new to this forum and have been lurking to see what you folks are made out of.
I asked the question "over there".
Curiosity gets the better of me and eventually I would have asked here.
Chris.

Good folks over here Chris, stick around. Joe

[Poochi55]

Mr Seijas informed me that the question has been posted on this forum. Have not been here in quite awhile, so I joined, and will post the answer to your question here shortly and hopefully some photos. I suspect the front sight screw is key to the attachment. Tony