hey guys,
i just acquired a few AOB-marked slides: one's a "B" inspector, the other a "C". Each of these slides, though, has what looks like a "W" stamped into the cup. Both are E279s (using the Carbine Club method), or they are Type III (using Riesch's method).
Both slides appear to be original finish, and it looks like those "W"s have been there for a looong time (bottom slide's W is a partial, but same lines/font as the top one).
I did a quick check in my books, and didn't see anything about lateral support (either way) between Winchester and IBM as far as slides go.
What do you guys think?
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.