Advice on a IBM and Saginaw

[shamrocks]

I have been on the lookout for a nice IBM with early features and ran across this one on GB. I would really appreciate some advice on this one as to the sights and cc. Thanks. I was also was looking at this Saginaw that I saw.

http://gunbroker.com/Auction/ViewIte...Item=125588201

http://gunbroker.com/Auction/ViewIte...Item=125860780

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[painter777]

The stamped CC on the IBM isn't right.
Notice how the cannon ball just seems to float in mid air.....

Regards
Charlie-painter777

[STU1]

IMHO both look restored especially the S'G' the rear sight appears to be a repro the barrel has what looks like an NPM punch stake marking behind the front sight (rebarrel receiver). the I.B.M. looks like the cannons have been stamped on recently i've provided a pic of a real stamp not the best angle but the one on the stock in the auction don't look right to me or like the one in the pic provided there is a give away i'll keep to myself for certain reasons. regards

Stu

[shamrocks]

Maybe it was the IBM cc that was bothering me...but I couldn't put my finger on it 'til you pointed that out. thanks guys.

[painter777]

Stock markings on the S'G' look right.
But look closely at the B-S'G' marked rear sight in picture number 4.
I don't have a B-S'G' marked one.......but you can see in the attached picture that the markings are wrong. Pay close attention to the style of the "S" and "G"

Shamrocks,
I'll PM the pic to you.

Regards
Charlie-painter777

[Bruce McAskill]

The serial number would indicate production about December 1943. If so then the barrel should be a dated barrel and the bolt is a round bolt that was not used till early in 1944. So it's not just the stock that is not quite right on this IBM. hth

[BrianQ]

The serial number would indicate production about December 1943. If so then the barrel should be a dated barrel and the bolt is a round bolt that was not used till early in 1944. So it's not just the stock that is not quite right on this IBM. hth

There are a few issues with the IBM but the barrel and bolt are correct for the serial number.

Undated barrels show up on IBM carbines from around serial number 3,796,xxx to the end of production. Round bolts were in use from serial number 3,744,xxx to the end of production.

[shamrocks]

much obliged guys! Charlie thanks for the picture of the sight. I don't have one to compare it with so that helped a lot.

[shamrocks]

Thanks for all the help guys...if you don't mind try looking at one more for me. The photos aren't all that great but the keen eyes you guys have helps out.

http://gunbroker.com/Auction/ViewIte...Item=126187663

[STU1]

Keep looking, that one isn't right either. if your going to spend the cash drop it on something that is worth it, not something that has been cobbled together.