Looking for two walnut "Normal" length SMLE III butt stocks.

I need pre WW2, original walnut stocks, that are not refinished, have sharp well defined edges, with unit disk pockets, and no repair cuts. Preferred with the buttplates.

One rifle is numbers matching, EFD, with unsanded wood, with sharp wood edges, and has very dark wood. The current butt has straight wide grain. Replacement must be in very good condition. Hoping for color match, grain is a bonus.

Not looking for much with the other butt. The rifle is the average color as restocked in the 30's. Just looking for VG condition, no unit disk not a deal breaker.

Looking for SMLE No 1 MK3 top handguard set.

Desired handguard set is also in the average color. VG condition. Brass pin or cross wood repairs acceptable. Will buy either handguard individually.

Looking for SMLE No 1 Mk 1 nose cap

Desired nose cap is the early flat vertical ear type, or an accurate reproduction of the same. Condition can be any condition, serviceable, with no bends or breaks. Light rust ok. Acceptable from Poor to very good. At this point I'll take any available.

Looking for LE1 safety spring screw

Early screw, see previous post.
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.