Paper Weight

[DustyRusty]

I bought a TRW M-14 receiver heel at Camp Perry one year. I thought I'd clean it up for a nice paper weight.

Today I thought a set of junk sights would look good. Then what about a selector knob? I thought I'd be best off by asking this question here.

What do I need to add to this guy & where can I look for them?
Not super fine funtioning parts, but paper weight grade.
Picture link below.

Dusty

Paper Weight.jpg - Google Drive

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[browningautorifle]

The sights should be easy to get, there are enough Norinco rifles around that cast off sights should be everywhere. I had three sets I sold just recently for $50CDN. The selector could be harder.

[DustyRusty]

Thanks Jim, Its looking to be just as you said.

[Jakeroub]

I have an M14 heel paperweight. I cut off the selector tab so it will sit flat on a table/desk/etc and was re-parked. Mine also has a rear sight and stripper clip guide installed.