No4mk1 clamp on fron sight

[Chainsaw311]

I have a sporterized,read cut barrel,no4mk1 enfield and I hate the look of the drill and tap scope base thats on it.I would rather shoot it with irons.Are there any options for a clamp on type front sight?

[tiriaq]

I am unaware of any clamp on front sight. You could drill and tap for a ramp, solder on a ramp, or make and install a banded front sight ramp.

[MAC702]

...solder on a ramp...

This. It's actually very doable for an amateur.

[Surpmil]

What length is the barrel from the font face of the receiver to the face of the muzzle?

[Chainsaw311]

What length is the barrel from the font face of the receiver to the face of the muzzle?

21 1/4".64 diameter

[Surpmil]

21 1/4".64 diameter

If you want the original sight graduations to match precisely at all ranges you'll need to cut it down to No.5 Rifle ("Jungle Carbine") length and fit one of the 800 yard backsights made for those.

Reproduction No.5 flash hiders / sight bases are still available I believe.

Otherwise, fit whatever you like as a foresight then mark the sight graduations appropriately after determining those on the range. If you grind off the original markings you will need to carefully adjust the back sight slide afterwards to ensure that is a close fit, unless you use a Mk.3 back sight.