I have a Winchester Model 1917 with an 8-18 dated Win. barrel. It has the original blue and was probably a Lend Lease rifle due to some red paint residue on the stock. The bore is immaculate and the head space is fine. The front sight blade is centered and staked.
I shot it for the first time today - 100 yards prone with the stock on a rest just ahead of the magazine. The ammo was LC69 ball. Before firing I tightened the action screws and handguard screws. The rear handguard is loose and moves fore and aft about 1/8th of an inch.
I used the rear leaf in the up position set at 200 yards. The barrel was clean and I fired three warm up shots into the backstop. My first two shots were three inches right but probably 14 inches low (did not measure). I raised the leaf to 400 yards and fired three more. This group was two to three inches right and about three inches high.
I fired seven more shots and the hits were walking progressively higher and to the right. I was single loading and firing two per minute.
QUESTIONS:
1. Why would it shoot so low?
--Were different height front sights available?
--Could poor bedding cause this?
2. Seems like poor bedding could cause the impacts to walk. Is there any info around on how to shim / tighten up / relieve the bedding on the M1917 to make it shoot better?
ThanksInformation
![]()
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.