-
FREE MEMBER
NO Posting or PM's Allowed
Marking on my carbine sight
Just noticed an H inside of a shield on my rear sight. Right side. The sight is unmarked otherwise.
The sight happens to be on a Plainfield carbine, if that helps
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
08-06-2011 11:27 PM
# ADS
Friends and Sponsors
-
Winchester used a milled and a stamped rear sight with an H in a shield. (6 into 7 million range) Hemphill Mfg. Co. Pawtucket, R.I.
-
The Following 2 Members Say Thank You to JimF4M1s (Deceased) For This Useful Post:
-
-
Legacy Member
Jim; My 5.6 Win has a stamped Hemphill that appears to have been on it since day one. I believe that they started using them sporadically in spring 44 mixed with flips as they came in. A lot of other 5.6 Wins like this.
-
-
Dave,
I know they were a bit earlier. War baby says later 6 to 7. Riesch says 5.7 for milled 6.45 for pressed. Newsletters have shown different dates over the years.
My point was even though it was on a Plainfield it could be a real USGI sight.
I have:
5.6 with a square S leaf sight
5.6 with milled H in shield (transition time?)
5.7 with pressed H in shield (not in the reported 6.45 range)
-
Thank You to JimF4M1s (Deceased) For This Useful Post:
-
Legacy Member
Plainfields in some cases had all-G.I. parts on a Plainfield receiver. I don't think there is such a thing as a non-G.I. Hemphill rear sight. Inland also used these very late after previously using the 'H.I.' (Hemphill for Inland) milled sights. They're also found on many rebuilds of all makers.
-