FAL Magazine Loader

[USMC6094]

I went to my local never-have-anything shop (gun shop in name only) and on a tabel with a bunch of used reloading dies, spent casings for sale and other dredgings I spied a black pressed metal fitting that was wider at one end than the other and had a square cut-out on the narrow end. I mustve remembered what it was and went on to look at a kinda bubba'd Swede 96 Mauser and a sporterized No4 MkI then made my way back to the table. I couldnt walk out without that loader.
Treasure is where you find it I guess and my newest only cost me two dollars.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[RCS]

Did your magazine loader look like this one ?

[USMC6094]

No its of the pressed and welded steel variety, parkereized underneath and painted black over that

[Paul S.]

Completely open on both ends right? One end fits onto an SLR magazine (out of the rifle of course), the stripper clips slide into the other end, press down on the rounds and walah!

[USMC6094]

Completely open on both ends right? One end fits onto an SLR magazine (out of the rifle of course), the stripper clips slide into the other end, press down on the rounds and walah!

Thats right, I'll post a picture or two alittle later today

[Sarge]

The FN/FAL loader looks a lot like the BAR loader.
I've got both.
Sarge