I Have An Underwood Carbine That Was Purchased In The 6os From The CMPicon. It Has A Barrel Date Of 1-43 With The Ord Bomb On The Barrel And Underwood Stamped Across The Barrel. The Receiver Is Also Underwood As Well. The Other Parts Are As Follows:

Slide Un Quality Hardware

Bolt Flat Un Quality Hardware

Trigger Group
Stamped Ibm Complete I Believe, Flip Safety With Horseshoe
Stamped On The Lever. And I Believe Ia On The Mag
Release Button.

Recoil Plate National Postal Meter

Rear Sight Milled Adjustable H Inside A Shield Mark On It

Front Sight Underwood U Marked

Barrel Band Type Iii E-mq On Barrel Band And U-nq Marked
On The Lug

Stock Winchester Low Wood Small W In Sling Well
Has P On Pistol Grip Crossed Cannons On The
Right Side Of The Butt And Aam On The Left Side
Of The Stock, Below The Receiver. Does Not Have
I Cut Out For The Oiler

Oiler Is

Handguard Sg

Best Part... It Survived Wwii And The Birmingham Riots
Without Rusting Or Pitting, And Has A Clean
And Bright Bore.

I Know It Went Through The Agusta Arsenal At Some Point, I Was Wondering If I Should Keep It As Is Or Should I Try To Replace The Non Underwood Parts? Its A Light And Very Acurate Weapon And It Can Eat Up The 10 And 9 Ring On A B27 Target, At 100 Yrds, With Ease.
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.