I checked hs on m1 w/ 1/2 muzzle and less then 1 on throat(from CMPicon)
and go and no-go were good. i used this as my bench mark. then i took hs on
2 ww2 receivered...1 sa,1wra, that had higher but not too high wear(m2,te3) the no-go
gauge allowed the bolts to close on both but it was not easy(some resistance)
i don't intend to fire these but could it be safe if i did. any info is appreciated as always.
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.