What is the proper or good bore for an 03A3?
I have an arsenal rebuild (one punch mark) and shows no wear on the green parker.
Unfortunately, doing a bullet test in the bore with commercial 150gr ammo.
Results are bullet is 1/16 to 1/32 from the case.
What is the reasonable bore diameter? As a welder and machinist, I have the tools and ability to measure these bores
properly.
What should I be looking for?
Many Thanks
brandeInformation
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.