I received my new stock for my 1903A3 from the CMPicon and it fits very nicely excely for one thing. The barrel is loose at the end and will wobble around with only very light pressure from my finger. I can only image it will not group well at all when fired. What holds the barrel down to the stock?

One thing I noticed was the handguard did not have inlets cut for the two clips so I did not install these. Are these two little clips what holds the barrel snug? If so, can anyone provide any measurements so I can attempt to cut the inlets in the handguards?

Thanks
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.