Hi folks,

I purchased a 1943 BSA No4 MkI T with mismatched No32 MkII scope last fall. Got it from Brian at BDLicon. The scope was refinished by Peter.

To date I've only had it out to the range a couple times, and only at 100 yards. Only 60 rounds through it so far. Using factory ammo I am getting pretty consistent 1.5 inch 5 shot groups. When I get around to working up some loads I expect that should tighten up even better.

So the question is, is there a way to adjust the scope so that the elevation and deflection drum settings match reality?

At 100 yards, in order to hit my point of aim, I've got the elevation set for 375 yards (3 clicks past 3) and the deflection is set 3 clicks from 0. I suppose I could keep a listings of setting for various distances, but I'd rather not.

I'm making an assumption here, but is this because the scope and bracket are mismatched to the rifle?

Thanks folks!
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.