I made a mistake setting up my 3006 die. I have pushed the shoulder back too far on about 200 pieces of brass. I'm about .006 shorter than a standard LC 69 M2 ball round and around .010 shorter than my chamber. The brass is LC 67 match once fired. I began working some loads up with the brass and began getting some primer back out. No leakage or piercing noted. The brass I fired showed 2-3 thousands of stretch, and 0-6 thousands of primer back out.I have since properly adjusted the die.
Are firing these dangerous? Should I scrap the lot?
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.