This is my first P#* that I purchased at t local gun show Sunday. It is an AC 41 (Walther manufacture, 1941?) and looks to be mostly matching. I brought it home, cleaned it up a little and brought it out to the range. I found it to be very accurate, and it chambered, fired, extracted and ejected every round flawlessly. But after about every third shot the slide would close with a round in the chamber, the hammer down and the trigger not reset. Pulling the hammer back would reset the trigger and I could fire the next round. At no time did it double. It was almost as if the safety was on and the hammer decocked. When I got it I tried the standard M1911 test or pulling and holding the trigger while manipulating the slide. In this case the hammer always followed the slide. I am not familiar with this action so I am not even sure that is a valid test.

Any suggestions or comments?

Pictures below.






Thanks

Howard
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.