@happydude I've been reloading for the 7.62x25 for my Type 54 for awhile, using a home load I came up with for H110, 13 grains under a 90gr pill. I've been using cheaply available Starline brass from a local dealer here in BC. I got started after I bought a bunch of milsurp ammo only to discover that they jammed like SOBs in the Type 54's chamber, something about the lacquer sticking or something; every third bloody shot.

Anyways, I highly recommend the Starline brass like JHC II said, it works good and responds well to resizing.

@davidjyoung Thanks for the tip on the .32 ACP rounds, I didn't realize they were actually .309, I've been looking everywhere for some round nose FMJs to replace the hollowpoints I've been using. I've been relying on the Hornady 90gr .309 XTPs so far and they're not bad, bet every once in a while they'll jam in the feed ramp. Part# is 31000 if you're looking. Round nose feeds like a dream but has been a bugger to find.

As far as the .32 H&R Mag goes, I'd probably leave that one alone, I believe it's closer to .315 and I'd be a little leary about chambering a pill that tight. Having said that, I haven't actually seen one to measure it, so it's all just numbers I've read, I could be wrong.

As for the 9mm barrel, I've been looking everywhere and there very hard to track down north of the border, the best thing I've found so far is to buy a $100 Type 54 (Norinco M213) and cannibalize it for the barrel, bushing, link and pin. Canadaammo.com has the M213s on for $99 right now.

Anyway, a little lengthy for my first post but what can you do?