Results 1 to 10 of 15

Thread: A couple of M1 Carbines

Click here to increase the font size Click here to reduce the font size

Threaded View

Dump1567 A couple of M1 Carbines 01-08-2012, 05:15 PM
shadycon Welcome; nice pair, The... 01-08-2012, 05:28 PM
frankderrico Ditto what shady said. The RS... 01-08-2012, 05:47 PM
Dump1567 Tried to clean-up the area. ... 01-08-2012, 06:16 PM
frankderrico Dump,the springs are most... 01-08-2012, 09:55 PM
tx81 Can you take a closer look by... 01-08-2012, 10:27 PM
Dump1567 I'm pretty sure it's Quality,... 01-08-2012, 10:43 PM
Dump1567 Internals. Quality Top... 01-09-2012, 09:58 PM
painter777 In the QHMC, Looks to be a... 01-10-2012, 09:51 AM
Dump1567 Thanks. I found the W. 01-11-2012, 10:45 AM
painter777 Looking at the right side of... 01-10-2012, 10:32 PM
Dump1567 No such luck. :( 01-11-2012, 10:24 PM
Dump1567 Took both out to shoot today.... 01-19-2012, 09:36 PM
USGI When I first got by Inland I... 01-20-2012, 10:08 PM
Dump1567 I ordered the parts and bolt... 01-21-2012, 06:48 PM
  1. #11
    Advisory Panel
    painter777's Avatar
    Join Date
    Mar 2009
    Last On
    @
    Location
    Central Michigan
    Posts
    5,493
    Local Date
    06-12-2025
    Local Time
    07:30 AM
    Looking at the right side of your full length view of the OI-Inland stock. Looks like the shadow of a Crossed Cannons stamp on the right rear/ just forward of the oiler slot.

    Is there a beveled slope between the front lugs on your Inland trigger Housing?
    That Inland Trigger Housing looks to have a trigger with the extra knotch on the backside of it. Hard to be sure from the angle, but if so, that would be a IP-S'G' trigger.
    The Hammer in it may be a SG or S'G', Marked near the bottom, where the pin runs thru.

    HTH,
    Charlie

    P.S. My mistake asking about front bevel on the Inland Trigger Housing. Was thinking it may be the eary Type I housing, But it wouldn't have the WIDE magwall. Looks as though it's a Type II. Sorry.... Bed Time Here !
    Last edited by painter777; 01-10-2012 at 10:56 PM. Reason: Fixing My Bad

Similar Threads

  1. Replies: 0
    Last Post: 08-26-2010, 08:20 PM
  2. Replies: 0
    Last Post: 08-26-2010, 08:17 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Loading...