I bought a NPM Carbine SN #1,492,883 1st block Jan 43- Sept 43 I know that it is a mixmaster but just hope is a good shooter.
Barrel - Underwood 6-43 flaming bomb - ME full 3/16" to case using M2 ball 30-06 HXP
Stock - Walnut wood - has been sanded - right side can just make out square but no letters. left side has a rebuild mark (looks like MC??. was hoping were some markings on inside of stock but none
Sling recess - in the top part has letters RSG or C
Center looks like Flaming Bomb ??
Bottom hard to make out, but looks like a S U ( maybe light struck O ) then a letter L Note I took a lot of pictures
Bottom of pistol grip is a stamped P
BAD part of the stock - some idot sanded down the top of the butt next to the buttplate ( you can see top of buttplate is higher than the wood the rest fits ok. I tried a new buttplate but did not help.
Trigger housing is a type 1 ??? marked N on right side & 9 on left side.
Hammer no marks ( I didn't take the trigger group apart yet )
BOLT- Flat no marks except on left lug that slides in the receiver slot had some marks ( maybe AL L & backward C ??? worn almost off. I didn't take bolt apart until I get bolt tool.
SLING - looks to be maybe USGI Post War ???
SLIDE - maybe type 3 ??? down in side the bottom is letter S & and #'s 17 on out side bottom.
Recoil Plate ( type 3 SG )
Post rebuild - Rear Sights HI, barrel band with lug type 3 MMQ, front sight RIA, 4 rivet hand guard with letters & numbers on inside, flip saftey,and M magazine catch.
OILER- looks to be a good one ???? maybe International Silver Co.

Maybe you guys can tell more by looking at the pictures ( I tried using Craig Riesch book but get mixed up )
All help will be appreciated
Thanks
Dick
NPM CARBINE pictures by montana19x - Photobucket
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.