I need a middle band formed to fit a rifle. It will require bending the oval band to the cross section shape of the stock and barrel, then cutting off the lower portion where the sling swivel and screw go. Then a sections of another band needs to be bent to form the lower shape of the stock, and the upper and lower sections brazed together. I have created the cross section of the rifle at the point where the band goes., and I have the two bands, swivel and screw. You can see what I was attempting in the attached pictures. I was successful on one side, but bent the metal too much on the other side, and it began to split.
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.