Am still trying to accurise the short Werder carbine. Principally working on loading the smaller carbine cases. They look perfect, but I took the bullet off a case recently and found that the grease behind the bullet had been pushed behind the closely fitting fibre wad and had contaminated the top layer of BP. Don´t quite see how this can be avoided. Any ideas?? I can get some rounds that are quite accurate at 100 metres. But the rest go all over the place and am glad that they at least end up on the target.
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.