I bought a pull throu reamer from Pacific T.& G.. I just reamed my first barrel with short head space. took the bolt apart . I reamed till the bolt closed.Cleaned then I check the head space with the Forster Go gauge the bolt did not close ??. I had to rereame a bite more for the bolt to colse on the Go gauge . Do you not have to take the bolt apart ?? . If you don't take the bolt apart the extractor seats on that little bearing on the back of the reamer. Would that not give to much head space. Thanks for any info.
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.