I have been reading several posts, concerning loads for the M-1 Garand rifle. There is alot of discussion of slow burning powders which causes high pressures which could damage the gas port.
My load for the Garand is:
150 FMJ BT bullet
Military brass
IMR 4350 53.0 Grains
Remington 91/2 primers
Should I purchase a adjustable gas plug when shooting this loads? Second question is where do you purchase this adjustable plug? Thanks in advance.
RoyInformation
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.