Hello all,
I am getting a parts kit prepared to build into a semi Bren. I have a nice kit MK1* type from Enfield..
I have a couple Lithgow MKII barrels that are new, never fired, and have the nicest bores I have ever seen on any gun. I also have a number of MK1 barrels ranging from very good to OK in condition. I would like to use both types for display and shooting. I can feel a difference with a .30 cal bore brush between the barrels, some are defiantly looser than others. I was thinking of machining some hard wax slugs I could push through the barrels and then measure them to get an idea of the wear. I could also machine a step gauge and check each end as well. I do have a small lathe at my disposal.
What is the best way to evaluate the bore condition, and what are acceptable tolerances for the Bren?Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.