I have owned this Webley revolver for many years. Peter helped me obtain a front sight screw a little while ago, so I thought it was time to try it out. I purchased some ammo & off to the range I went.

Unfortunately, the firing pin just misses the primer. The double action trigger is absolutely exquisite, but no bang. I am bummed. It does not appear that the firing pin has been shaved, however I guess that it is possible. In any event, it will not fire.

Any ideas how I can remedy this? The firing pin seems to be attached in a way that will make it very difficult to repair, even if I can find one.

Any advice?
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.