Hi gents,
Finally, after 5 years of long wait, I started to fit a repro bracket with a n°32 MkI.
I read, read again, and drunk a lot of whisky as described in the nice documentation written by Mr Laidlericon. I'm sticking to any step described, and everything was going well until the fitting of the rear pad. When I aim a DAP at 250 yards through the barrel and set the drum to 250 yards on the scope, the grat on the DAP, my rear pad is positioned as follow ...
I measured the pad, the bracket, the size shows some minor differences with the blueprint, but not at a point to get so much gap. What did I not do? what should I do to correct this, if possible..
Thank you
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.