Quote Originally Posted by ssgross View Post
Jon - are you saying the feed angle at the joint needs to be lessened? If I hear you right - removing some material from where the side-plate and receiver mate would make the feed slot closer to parallel with the receiver (of course I don't mean grind it parallel, just grind or file in that direction) ...
Attachment 110996

I was thinking of the case where the bullet nose is snagging on the joint between the side plate and receiver. Not taking out a lot of material, just smoothing that joint. If the round isn't getting pointed into the chamber that is something different - maybe a new used sideplate would do the job. I've never had THAT particular problem.

Good luck!

jn