Here's a odd one. A OI Inland bolt that had a Modified to fit Garand Extractor in it. The Plunger appears to be a Carbine late style that either thru use or more modifying has the tip peened over.

The owner said: "Looking closer I can definitely see how this extractor was "edited" to fit. Whoever did it seems to have done it well, the lines are very clean, and the corners sharp. The bottom edge was actually taken down to be flush with the bolt lug."
"The gun ran very well, but I only have put 50-60 rounds through it at a time before cleaning it."


Attachment 113466Attachment 113467Attachment 113468

Below a Picture of a Garand / M14icon Extractor before Bubba modifies it to work on a Carbine Bolt.



Merry Christmas All,
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.