I am converting a sporter mk1* and the last part I need to remove is this one piece that no one seems to name on the parts sites. BRP does show it on their schematics but there is not a name and the parts are not in stock.

Parts 33 and 34...which was replaced by a screw on the Mk2 stock. I have the parts on my sporter stock but am not sure how to remove them from there without damaging the stock. It appears this piece is pinned in which would require me to drill through my repro stock as that and a few other cuts were missed.

Or I could use the Mk2 pakistani stock i got at auction though I would rather stash that one or sell it off.

Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.