Dodged a bullet, so to speak. It's my IAI M1icon with all GI parts but the barreled receiver. Loaded a magazine, aimed, fired. Ok. Aimed, pulled the trigger, CLICK. Hammer fell, no BANG. I looked down, the bullet was half chambered.

I cleared the round and worked the hammer for a function check. Seemed ok. Then I held the slide back about an inch and pulled the trigger, CLICK! Hammer fell and I saw the firing pin move. Sure enough, the round that was half in had a really small dimple. Lucky today.

I don't think that it should do that, and how do I fix it?
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.