Is my M1917 shooting low.

[Patrick Chadwick]

Yes, it could be the sight calibration, but it could also be a warped stock pulling down at the front end. Easy to check: Remove the upper band. In fact you can only slide it up to the foresight block (the "ears), but that is enough. Has the barrel risen right up in the channel? Since you cannor remove the band completely, slide a bit of felt or cloth between the band and the barrel, so that you can test fire a couple of shot without the rattling band scratching the barrel surface.

If the point of impact is now several inches higher, then the band was pulling the barrel down, and you will have to rectify that fault before doing anything else. While the band is loose, you might as well remove both handguards and check that there is no contact between the barrel and the wood anywhere along the channel. Now replace the upper band, but not the handguards. If a binding now occurs somewhere between upper band and the barrel shoulder, then the stock is warped and has been trying to bend the barrel around the tight spot.

If this is all OK, then don't worry too much. As Noro wrote, the ammo used for sight calibration was different, and my M1917 also requires the 200 yard setting for 100 yds.

Patrick

Patrick